For years the SMP has been admired for its powerful drive mechanism and the blending of dry mortars. This is made possible by m-tec’s own dual mixing system with double blending: two separate mixing zones guarantee a constant mortar consistency at all times, irrespective of the level of wear on the worm pump. The result: very good, homogeneous mortar quality, even with products that are hard to blend.

The SMP silo mixing pump is available in versions for processing pumpable plaster, fire-proof material, floor screeds and adhesives. For small volumes the SMP can also be fed with bagged material.

As is typical of all m-tec systems, the SMP has easy and quick to use tensioning wedges, or swivelling devices that enable important elements such as the worm pump to be replaced in just a few seconds.

Easy Mix
Our patented mixing system enables an extremely good mixing quality. When used in conjunction with double blending, the system guarantees the best possible mortar products.


Easy Use
The combination of clearly arranged controls, a fold-out mixing zone, drive motors or tensioning wedges make the SMP silo mixing pump extremely easy to handle.

Easy Life
Thanks to the extremely long conveying distance, there is no need to waste time and effort changing over the application machine. This gives you more time to do your work.

• Lime plasters
• Lime cement plasters
• Bricklaying mortar
• Insulating plasters
• Finishing plasters
• Reinforcing mortar and adhesive mortar
• Adhesives
• Upgraded products

• Conveying pressure: up to 30 bar *
• Drive motors, mixing area: 4.0 kW, 400 V, 50 Hz
• Pumping area: 5.5 kW / 7.5 kW, 400V, 50 Hz (SMP-P /SMP-FE)
• Compressed air supply: 0.9 kW, approx. 250 l/min, 4 bar (SMP-P)
• Water pump: 0.3 kW / 0.55 kW, approx. 40 l/min /60 l/min, 8 bar (SMP-P /SMP-FE)
• Electrical connection: 400 V, 50 Hz, 3 ph
• Fuse: 25 A / 35 A
• Connecting cable:  5 x 4.0 mm²
• Connector: 32 A, 5p, 6h
• Water supply: 3/4“ water hose with GEKA coupling,
• Dimensions: approx. 2,200 x 800 x 1,850 mm or approx. 2350 x 800 x 1,900 mm (SMP-P /SMP-FE)
• required. Silo outlet height: approx. 1,300 mm or approx. 1,400 mm (SMP-P / SMP-FE)

* Depending on  consistency, quality and composition of the material, pump model - and condition, diameter and length of the delivery hose and also the pumping height of the material.