Pump P25 has a powerful 5.5kW motor. Together with the standard frequency converter (FU) this enables output to be regulated continuously, so that it can be adjusted to the various products. Naturally the P25 has connections for operation with a compressor and for fully automatic feeding by means of a mixer. Electronic hose pressure control and cut-off are available as an option.

The transparent layout of the controls and the conscious avoidance of superfluous switches make for easy operation. In addition, the easily dismantled material container enables fast cleaning.

The large wheels support problem-free transport on the building site. Naturally, pump P25 is also designed to be transported using a crane. As is typical of all m-tec systems, the P25 has easy and quick to use tensioning wedges that enable important elements such as the material container or worm pump to be replaced in just a few seconds.

Easy Clean
Easy, fast cleaning, thanks to the easily dismantled material container.

Easy Pump
The use of a frequency converter enables the pump motor to be started at full power and permits a continuously adjustable output.

• Lime cement plasters
• Finishing plasters
• Reinforcing mortar and adhesive mortar
• Thin layer filling compounds
• Fillers

• Delivery pressure:* up to 40 bar
• Drive motor: 5.5 kW, 400 V, 50 Hz
• Electrical connection: 400V, 50 Hz, 1/3 ph
• Fuse: 25 A
• Connecting cable: 5 x 4.0 mm²
• Connector: 32A 5p 6h
• Dimensions: approx. 1900 x 500 x 560 mm
• Weight: approx. 100 kg

* Depending on consistency, quality and composition of the material, pump model - and condition, diameter and length of the delivery hose and also the pumping height of the material.

• Compressor
• Remote control cable
• Fine plaster spray gun
• Adhesive gun