print 
Continuous mixer type MR - mixing technology with residue-free discharge
MR mixers from m-tec have a mixing system that has been proven many times in practice. They work according to the centrifugal mixing principle: in this case a special mixer construction causes a three-dimensional particle movement in the components to be mixed, guaranteeing excellent mixing quality with short mixing times.Mixing tools and mixer drive performance, size and material are tailored to the specific material to be mixed. Special centrifugal blades - in wear-resistant materials if necessary - ensure an intensive, yet gentle mixing process. This makes it possible to avoid most damage to granulated material and to prevent material from being crushed between the mixing tool and the mixer housing.
In addition, the use of agitators fitted with special mixer tools means that additional mixing energy can be applied to the material to be mixed. This means that agglomerates, pigments and fibres can be processed without difficulty.
The mixer arms are attached to the mixing shaft by means of push-on connections with adjusting screws. This enables the angles and wheelbase of the mixing tools to be adjusted quickly and tools to be replaced at speed.
MR mixers are notable for their residue-free mixer discharge systems: The contents of the mixer are discharged into an underhopper by means of two broad discharge flaps that cover the entire length of the mixer. Only a miniscule amount of residue is left in the mixer.
The simple, yet technically sophisticated, design of the discharge system means that it is dust-proof and requires little maintenance. Fast mixer discharging saves time and therefore energy and also considerably increases the capacity of the mixer. This makes it possible to combat any tendency towards demixing to optimum effect. Another advantage: While the product is continuously discharged from the underhopper, the system can start to mix a new batch.
MR type mixers are characterized by the long service life of the mixer shaft seal, thanks to a specially developed sealing lip system. Naturally, conventional compression gland or air gap seals can be provided.
The mixer arms are attached to the mixing shaft by means of push-on connections with adjusting screws. This enables the angles and wheelbase of the mixing tools to be adjusted quickly and tools to be replaced at speed.
MR mixers are notable for their residue-free mixer discharge systems: The contents of the mixer are discharged into an underhopper by means of two broad discharge flaps that cover the entire length of the mixer. Only a miniscule amount of residue is left in the mixer.
The simple, yet technically sophisticated, design of the discharge system means that it is dust-proof and requires little maintenance. Fast mixer discharging saves time and therefore energy and also considerably increases the capacity of the mixer. This makes it possible to combat any tendency towards demixing to optimum effect. Another advantage: While the product is continuously discharged from the underhopper, the system can start to mix a new batch.
MR type mixers are characterized by the long service life of the mixer shaft seal, thanks to a specially developed sealing lip system. Naturally, conventional compression gland or air gap seals can be provided.
Highlights:
- The greatest possible avoidance of manual cleaning or cleaning batches thanks to residue-free discharge
- Relief for subsequent conveying mechanisms thanks to quasi-continuous production. This makes it possible to use smaller conveying mechanisms.
- Gentle mixing using special mixing blade geometry
- Economic efficiency thanks to low power consumption
- Can handle almost any mixing task